To move a gate, click the mouse cursor once in the gate that you wish to move. This will activate the gate. The cursor will change to the drag cursor and resizing handles will appear on the vertices of the gate. To move the gate, click and hold the mouse button down anywhere inside the gate. Move the cursor while the mouse button is pressed, and the gate will move with the cursor. Release the mouse to drop the gate into the new position.

 

If one gate falls within the boundaries of a second gate you may right click on the plot→Activate gate→select the underlying gate. The position of the underlying gate may now be changed.

 

To cancel a gate move once you have begun, press and hold the Esc key and release the mouse button before you release the Esc key.

 

If you move a gate onto a blank part of a page, you will either:

 

 

 

according to the options you set in the Gate moving options section on the Gate page of the Options dialog.